diff --git a/hinges.scad b/hinges.scad index e78ae5c..93a5d5b 100644 --- a/hinges.scad +++ b/hinges.scad @@ -107,7 +107,7 @@ include // cones to interlock the hinge segments. The default cones are 45 degrees; you can set `in_place` to an // angle from the vertical to adjust the cone angle. (This means larger angles are pointier, and also less likely to print successfully.) // Use `gap` to adjust the clearance in the hinge -// to get something that separates after printing. When you adjust the cone hangle, higher angles result in a smaller +// to get something that separates after printing. When you adjust the cone angle, higher angles result in a smaller // clearance where the cones meet for the same gap size, so you can somewhat adjust the tightness of the hinge // by changing the cone angle. The default cone diameter, which is controlled by `pin_diam` is 1 unit smaller than the knuckle diameter, which should work well // for larger hinges, but for small hinges you may want to specify a larger `pin_diam`.